TM 9-2350-222-20-1-4
BRAKE CONTROL PEDAL AND BRACKET REPAIR AND
REPLACEMENT (Sheet 4 of 5)
INSTALLATION:
1.
Thread nut (A) onto screw (B).
2.
Position lever assembly (C) and two washers (D)
in bracket (E). Insert pin (F).
3.
Using slip joint pliers, rotate pin (F) to aline
hole with hole in bracket (E).
4.
Using hammer, drive new spring pin (G) into
holes of bracket (E) and pin (F).
5.
Place washer (H) on screw (J). Insert screw in
rear mounting hole of bracket (E).
6.
Position lever assembly (K) and two washers (L)
in bracket (E). Insert pin (M).
7.
Using slip joint pliers, rotate pin (M) to aline
hole with hole in bracket (E).
8.
Using hammer, drive new spring pin (N)
through holes of bracket (E) and pin (M).
GO on to Sheet 5
TA14033521
13-27