TM 9-2350-222-20-1-5
HYDRAULIC SELECTOR CONTROL VALVE REPLACEMENT (Sheet 7 of 8)
18.
Aline tube (R) with elbow (C).
19.
Using 1-5/8 inch wrench, tighten nut (S).
20.
Start nut (T) on elbow (C), and using 1-1/2
inch wrench, tighten nut (T) on elbow (C).
Install packing (U) on union (V).
21.
22.
Using 1-5/8 inch wrench, install union (V)
into valve (F) as shown.
23.
Install nut and packing onto elbow (W)
as shown in step 2.
24. By hand, install elbow (W) onto filter (X) as shown.
25. Install tube (Y) onto union (V) and elbow
(W) as shown.
26. Using 1-5/8 inch wrench, tighten nut (Z).
27. Using 1-1/2 inch wrench, tighten nuts (AA) and
(AB) onto elbow (W) and union (V).
28. Position clamp (AC) around tubes (R) and (AD).
29. Using 9/16 inch socket, install screw and new
lockwasher (AE) onto clamp (AC).
Go on to Sheet 8
TA141178
18-76