TM 9-2350-222-20-1-5
DRIVER'S HATCH NIGHT VIEWER LATCH REPAIR (Sheet 6 of 10)
Insert shaft (F) with offset threaded portion
5.
in down position (nearest support (A)
and tooling hole facing you).
6.
Line up loop of spring (D) with holes of
sleeve (E) and shaft (F).
7.
Place washer (G) on pin (H) and insert pin
from the back side.
8.
Insert new cotter pin (J) through hole in
pin (H).
9.
Using screwdriver and pliers, bend legs of
cotter pin (J).
NOTE
If handle was not disassembled, go to step 13.
10.
Place lever (K) on bench and, using ham-
mer, drive pin (L) partly through lever.
11.
Place handle (M) on bench and position
spring (N) in recess of handle and lever (K).
12.
Using hammer, drive pin (L) through lever
(K) and handle (M).
I
Go on to Sheet 7
16-122.18