TM 9-2350-222-20-1-5
DRIVER'S HATCH NIGHT VIEWER LATCH REPAIR (Sheet 9 of 10)
If operating push rod parts were not disassembled, proceed to step 29.
24. Start nut (S) onto rod (T) with locking
collar first. Run it on to about 1/4 inch of
end of threads. Use 1/2 inch wrench if
locking collar is tight. Use vise if neces-
sary.
Place sleeve (U) on rod (T).
26. Insert pivot (V) in plunger (W). Using hammer, drive in two pins (X) through pivot (V).
NOTE
Position pins (X) through pivot (V) so that they each stick
through pivot equally on both sides.
27. Pivot (V) has flat faces on two surfaces. Rotate pivot so smaller flat face is facing sleeve (U). Slide
pivot on rod (T).
28. Using socket, install nut (Y) while holding nut (S) with 1/2 inch wrench.
Go to Sheet 10
TA253629
16-122.21