DRIVER'S HATCH NIGHT VIEWER LATCH REPAIR (Sheet 8 of 10)
With one person relieving load with
punch, remove drill bit and handle (M).
Place spacer (Q) and handle (M) on shaft (F).
Using hammer, drive pin (R) into retaining
hole of handle (M) and shaft (F).
Release lever (K) and push handle (M)
forward 1/2 turn to locked position.
Release and return to position shown.
Handle should lock in both forward and aft positions and
should not bind during movement.
22. Remove assembled parts from vise.
Go on to Sheet 9