DRIVER'S HATCH LATCH (HOLD OPEN) AND STOP REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
Using hammer, drive pin (A) into hole in latch
1.
(B).
2.
Position latch assembly (B) and spring (C)
between mounting ears of hatch (D) and insert
pin (E).
3.
Retain pin (E) with two new cotter pins (F).
Spread legs of cotter pins.
Thread nut (G) onto setscrew (H) and, using 1/2
4.
inch wrench, run setscrew (H) through hatch
(D).
5.
Carefully move hatch (D) to closed position.
6.
Using 1/2 inch wrench, tighten setscrew (H)
until it contacts block (J).
7.
Using 1/2 inch wrench, hold setscrew (H) in
position and, using 3/4 inch wrench, tighten
nut (G) to secure setscrew (H).
End of Task
TA140713