BRAKE SWITCH (STOPLIGHT) REPLACEMENT (Sheet 2 of 2)
Using 1 inch wrench, install brake switch (A).
Apply silicone compound (Item 32, Appendix D) to connector (B) and plug into brake switch (A).
Using 1-1/8 inch wrench, remove cap (C) and check brake fluid level. Fill as necessary and install
Perform brake bleeding procedure (page 13-12, steps 3 thru 11).
Press (not pump) brake pedal. Check that gage (D) indicates 800 to 1000 psi and pedal movement
is firm, not spongy.
Check that brake lights work properly (TM 9-2350-222-10).
Place shift lever in P (park) position (TM 9-2350-222-10).
Remove blocks from tracks (TM 9-2350-222-10).
End of Task