BRAKE QUICK-DISCONNECT AND HOSE ASSEMBLY REPLACEMENT (Sheet 5 of 7)
Remove plastic plugs from tube assemblies (E) and (F) and position assembled parts (A) thru (D)
with tee (D) between tube assemblies (E) and (F).
Tighten nuts of tube assemblies (E) and (F) to tee (D) finger tight.
Remove screw (G) and lockwasher (H) holding
adjusting screw lock plate. Throw lockwasher away.
Position bracket (B) over adjusting screw lock
plate and insert screw (G) and new lockwasher
(H). Tighten finger tight.
Using 9/16 inch socket, tighten screw (G).
Using 11/16 inch wrench, tighten nuts of tube
assemblies (E) and (F).
Using 11/16 inch wrench, tighten nut of tee (D).
Thread nut of tee (J) on coupling half (K) finger
Using 3/4 inch wrench to hold coupling half (K)
and 11/ 16 inch wrench on nut of tee (J), tighten
Go on to Sheet 6