DOMELIGHT ASSEMBLY REPLACEMENT (Sheet 2 of 2)
Place resistor assembly (A) and clamp (B) in position on domelight assembly (C).
Insert two screws (D), new lockwashers (E), and flat washers (F) in screw holes of domelight
Place two new lockwashers (G) over screws (D).
Aline domelight (C) on mounting bracket of vehicle.
Tighten screws (D) with fingers.
Using socket, install two remaining screws (H), new lockwashers (J), and new lockwashers (K).
Using socket, tighten two screws (H).
Using fingers, connect electrical connectors (L).
End of Task