TM 9-2350-222-20-1-4
BRAKE SWITCH (STOPLIGHT) REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
1.
Using 1 inch wrench, install brake switch (A).
2.
Apply silicone compound (Item 32, Appendix D) to connector (B) and plug into brake switch (A).
3.
Using 1-1/8 inch wrench, remove cap (C) and check brake fluid level. Fill as necessary and install
cap (C).
4.
Perform brake bleeding procedure (page 13-12, steps 3 thru 11).
5.
Press (not pump) brake pedal. Check that gage (D) indicates 800 to 1000 psi and pedal movement
is firm, not spongy.
6.
Check that brake lights work properly (TM 9-2350-222-10).
7.
Place shift lever in P (park) position (TM 9-2350-222-10).
8.
Remove blocks from tracks (TM 9-2350-222-10).
End of Task
TA140354
13-46