TM 9-2350-222-34-1
HYDRAULIC RESERVOIR REPLACEMENT (Sheet 8 of 15)
38.
Using 1/2 inch wrench, remove eight locknuts
(BZ), two gaskets (CA), flange (CB), and shutoff
valve (CC). Throw gaskets (CA) away.
39.
Using 7/16 inch wrench, remove two screws
(CD), washers (CE), and spring clip (CF).
INSTALLATION:
1.
Using 7/16 inch wrench, install two screws (A),
washers (B), and spring clip (C).
2.
Position two new gaskets (D), shutoff valve (E),
and flange (F) on eight studs.
3.
Using 1/2 inch wrench, install eight locknuts (G)
on eight studs.
4.
Using 1-1/8 inch wrench, install breather filter
(H).
5.
Position and slip filler neck (J) portion of cap (K)
into reservoir (L).
6.
Turn cap (K) clockwise to secure.
7.
Insert oil level gage (M) and secure it by turning
the cap clockwise.
Go on to Sheet 9
TA130834
12-9
