TM 9-2350-222-34-1
STEERING CONTROL ROD REPLACEMENT (Sheet 1 of 2)
TOOLS: 5/8 in. combination box and open end wrench (2 required)
REFERENCES: TM 9-2350-222-20-1
PRELIMINARY PROCEDURES:
Remove left fuel tank (Page 4-51)
Remove outer riser link shield at rear of powerplant (TM 9-2350-222-
20-1)
Remove support straps (page 10-10)
Remove rear steering linkage shield and rear control rod (page 10-10)
REMOVAL:
NOTE
Connecting rod is located at left side of
powerplant compartment.
1. Pull shield (A) to rear of vehicle and remove.
NOTE
Go to turret compartment and locate left
access hatch.
2. Using one 5/8 inch wrench to hold plug (B) and other
5/8 inch wrench on end of rod (C), remove rod (C).
Go on to Sheet 2
TA130788
10-0-8
18
