TM 9-2350-222-34-1
STEERING CONTROL SLEEVE ASSEMBLY REPLACEMENT (Sheet 2 of 2)
3. Using 9/16 inch wrench, remove nut (D)
from bulkhead shaft (E).
4. Using 7/16 inch wrench on screw locking
nuts (F), loosen and remove nuts (F) and
setscrews (G).
5. Slide sleeve assembly (H) toward front of
vehicle and off shaft (E).
INSTALLATION:
1. Slide sleeve assembly (A) over shaft assembly
4. Using one 9/16 inch wrench to hold nut (E),
(B) as far as it will go.
use other 9/16 inch wrench to install rod end
(F) into shaft (B).
2. Using 7/16 inch wrench to hold nut (C),
install two screws (D) through lock nuts
5. Position rod end (F) into clevis end (G) and,
(C) into sleeve (A) until screws bottom out
using 9/16 inch wrench, install screw (H)
on hull connector. Using screwdriver, hold
through rod end (F) and clevis end (G).
screw (D) and, using torque wrench and
7/16 inch crowfoot wrench, tighten nut (C)
6. Adjust steering linkage (TM 9-2350-222-20-1).
to 810 lb-ft (10-13 Nm).
3. Using 9/16 inch wrench, install nut (E)
onto shaft (B).
End of Task
TA252644
Change 1 10-4
Change 1 10-4
