TM 9-2350-222-34-1
STEERING SHAFT ASSEMBLY REPAIR AND REPLACEMENT (Sheet 3 of 3)
3. Remove shaft assembly (A) from vise and take it to turret compartment.
4. Position shaft assembly (A) onto shaft (F). Using 5/8 inch wrench to hold jamnut (G), use 5/8 inch wrench on plug
(H) and tighten plug (H) against jamnut (G).
5. Install steering control sleeve (page 10-4).
6. Connect rear steering control rod end (page 10-18 and 19, steps 6-10).
7. Adjust steering linkage (TM 9-2350-222-20-1).
End of Task
TA130787
10-7
