TM 9-2350-222-34-1
FINAL DRIVE REPAIR (Sheet 11 of 30)
50. Using bearing puller or hammer and drift,
remove bearings (AF early model) or bearing
inner races (AG late model) from pinion (F).
Throw away pinion bearings and races.
51. Pinion bearings (AF or AG) must be replaced as
part of overhaul.
52. Remove spacer (AH) from output shaft (AJ).
53. Inspect spacer (AH) for damage or pitting.
54. If unserviceable, discard, or fabricate special
tool.
NOTE
Spacer (AH) may be used to fabricate
the special tool required to seat
output shaft and drive gear bergs
Go on to Sheet 12
Change 3 7-11
