TM 9-2350-222-34-1
FINAL DRIVE REPAIR (Sheet 9 of 30)
38. If any measurement is not within tolerance,
reassemble
final
drive
and
tag
"UNSERVICEABLE
(CARRIER
POCKET
DEPTH)." Return final drive to supply for depot
rework.
39. Using inside micrometer, measure carrier
bearing bore (AB) diameter a minimum of four
times in four equally spaced points. Record
readings.
40. If all measurements are between 5.5112 and
5.5130 inches (139.9845 and 140.0302 mm), go
to step 42.
41. If any measurement is not within tolerance,
reassemble
final
drive
and
tag
"UNSERVICEABLE
(CARRIER
BEARING
BORE)." Return final drive to supply for depot
rework.
NOTE
Ensure ease (Q) bearing cap surface
(AC) and gasket surface (AD) are
clean.
42. Position case (Q) on wood blocks with gasket
surface (AD) down.
43. Hold parallel straight bar in place across gasket
surface (AD) below bearing bore (AE).
Go on to Sheet 10
Change 5 7-9
