TM 9-2350-222-34-1
NOTE
Bearing installer is fabricated from spacers
(8689162). Two installers are required for output
shaft bearing installation.
Modify spacer (8689162) as follows:
a. Using hand grinder, or other suitable tool,
enlarge openings at each end of spacer enough
to allow spacer to slip onto output shaft without
binding.
b. Remove all nicks and burrs.
c. Mark modified spacer
"UNSERVICABLE-PRESS ONLY."
Figure 4. Final drive output shaft and drive bearing installer.
NOTE
Two attachments are required.
unused stud or bolt to maintain thread alignment
and weld together per TM 9-237.
2. Obtain eye (NSN 2520-00-840-4560).
Cut off
and throw away threaded portion.
3. Weld modified eye to welded nut assembly per
TM 9-237.
Figure 5. Final drive lifting attachment.
Change 3 D-3/(D-4 blank)