TM 9-2350-222-34-1
SHIFTING CONTROL SLEEVE ASSEMBLY REPLACEMENT (Sheet 2 of 2)
3.
Using 9/16 inch wrench, remove nut (D) from
bulkhead shaft (E).
4. Using 7/16 inch wrench on screw locking nuts (F),
loosen and remove nuts (F) and screws (G).
5. Slide sleeve assembly ((H) toward front of vehicle and
off shaft (E).
INSTALLATION:
1. Slide sleeve assembly (A) over shaft assembly (B)
as far as it will go.
2.
Using 7/16 inch wrench to hold nut (C), install two
sleeve holding screws (D) through nuts (C) into
sleeve (A) until screws bottom out on hull
connector. Using torque wrench and 7/16 inch
socket, hold screw and tighten nut (C) to 7.5 lb-ft
(10 N m).
3.
Using 9/16 inch wrench, install nut (E) onto shaft
(B).
4.
Using one 9/16 inch wrench to hold nut (E), use
other 9/16 inch wrench to install rod end (F) onto
shaft (B). Using torque wrench and 9/16 inch
crowfoot, tighten rod end (F) to 15- 20 lb-ft (20-27
N.m).
5.
Position rod end (F) into clevis end (G) and, using
9/16 inch wrench, install screw (H) through rod end
(F) and clevis end (G). Using torque wrench and
9/16 inch socket tighten screw to 15-20 lb-ft (20-27
N.m).
6.
Perform shifting control adjustment as required (TM
9-2350-222-20-1).
End or Task
Change 1 6-11
