TM 9-2350-222-34-1
SHIFTING CONNECTING LINK REPLACEMENT AND REPAIR (Sheet 3 of 3)
3. Remove shaft assembly (A) from vise and take it to turret compartment.
4. Position shaft assembly (A) onto shaft (F). Using 5/8 inch wrench to holdjamnut (G), use other 5/8 inch wrench on plug
(D), tighten plug (D) against jamnut (G).
5. Install shifting control sleeve (page 6-11).
6. Install rod assembly, engine compartment rear rod (TM 9-2350-222-20-1).
7. Adjust shifting linkage (TM 9-2350-222-20-1).
End of Task
TA130684
6-14
