TM 9-2350-222-341
SHIFTING BELLCRANK REPLACEMENT (Sheet 2 of 3)
5. Inspect bearing (H).
If bearing needs replacing,
proceed to step 6.
6. Position bellcrank (F) in vise and, using hammer and
drive punch, remove bearing (H) from bellcrank (F).
INSTALLATION:
1. If new bearing is needed, use vise and install bearing
(A) into bellcrank (B). If new bearing is not needed,
proceed to step 2.
2. Position washer (C), bellcrank (B), washer (D), and
washer (E) onto stud (F).
3. Using socket and ratchet, install nut (G) onto stud
(F).
4. Using pliers, install new cotter pin (H) through nut
(G) and stud (F).
TA252632
Go on to Sheet 3
Change 1 6-3
