TM 9-2360-222-34-1
FUEL PRIMER INLET TO ENGINE TUBE ASSEMBLY REPLACEMENT (EARLY MODEL)
(Sheet 2 of 6)
NOTE
Gain access to rear of bulkhead
through left bulkhead access opening
located in turret compartment.
3. Using 9/16 inch wrench, reach through access
opening (H) and disconnect front nut of tube (D)
from bulkhead nipple (J).
4. Using 7/16 inch socket, remove screw (K) and
lockwasher (L) holding front clamp (M) and tube
5. Remove tube (D) through engine compartment.
6. Remove three clamps (C), (G), and (M) from
tube (D).
Go on to Sheet 3
TA252607
Change 1 4-81