TM 9-2350-222-20-2-3-2
M240 MACHINE GUN MOUNT DISASSEMBLY PROCEDURE (CONT)
35-8.
FRAME 2
STEP
PROCEDURE
1.
Using Allen wrench, remove screw (1).
2.
Using screwdriver, remove retaining clip (2) and pull out front pin (3) from mounting block (4).
3.
Using 1/8 inch punch and hammer, remove two spring pins (5).
4.
Using screwdriver, open end of ring (6) and remove ring from front pin (3).
5.
Using combination wrench, remove nut (7) and flat washer (8) that attach front mounting block (4) to
gun mount base (10).
6.
Using Allen wrench, remove screw (10).
7.
Using screwdriver, remove retaining clip (11) and pull out rear pin (12).
8.
Using screwdriver, open end of ring (13) and remove ring from rear pin (12).
GO TO FRAME 3
Para 36-8 Cont
35-30 Change 1
