TM 9-2350-222-2-3-2
M240 MACHINE GUN MOUNT DISASSEMBLY PROCEDURE (CONT)
35-8.
FRAME 1
PROCEDURE
STEP
1.
Using hammer and 1/8 inch punch, carefully remove spring roll pin (1) that attaches solenoid clevis
2) to manual trigger (3).
2.
Using cutting pliers, remove lockwire from three screws (4) (JPG).
Using 7/16 inch wrench, remove three screws (4).
3.
NOTE
Do not turn solenoid clevis (2) as additional adjustment will be
required during assembly.
Remove solenoid (5) from aligning pin and gun mount (6).
4.
NOTE
If solenoid (5) or solenoid clevis (2) is to be replaced, do step 5,
otherwise go to step 6.
5.
Unscrew and remove solenoid clevis (2) from solenoid (5).
6.
Using hammer and 1/16 inch punch, remove spring roll pins (7) that secure trigger roller pin (8) to
trigger actuator lever (9).
7.
Remove trigger roller pin and trigger roller (10).
8.
Using hammer and 1/8 inch punch, remove spring roll pin (11) that attaches manual trigger (3) to
trigger linkage shaft (12).
9.
Using hammer and 1/8 inch punch, remove second spring roll pin (11) that attaches trigger linkage
shaft (12) to trigger actuator lever (9).
10.
Remove manual trigger (3), trigger linkage shaft (12), and trigger actuator lever (9).
GO TO FRAME 2
Para 35-8 Cont
35-28 Change 1
