TM 9-2350-222-20-1-5
SMOKE GENERATOR ENGINE WIRING HARNESS REPLACEMENT (Sheet 7 of 7)
12.
Install sleeving (N) over wiring harness (F).
13.
Insert wiring harness (F) through retaining nut
(P) and bushing (Q).
14.
Using solder (Item 63, Appendix D) and
soldering gun, attach pin (R) to wiring harness
(F).
15.
Install pin (R) into hole `A' of insert (S).
16.
Push pin (R) and insert (S) into position in shell
(L).
17.
Slide bushing (Q) against insert (S).
18.
Slide sleeving (N) against bushing (Q).
19.
Install retaining nut (P) on shell (L).
Place connector (T) in position in bracket (M).
Using screwdriver and 3/8 inch wrench,
install four screws and four nuts (U).
Install connector (V).
Install engine shroud (page 9-3).
End of Task
TA140903
23-51 (23-52 blank)
