TM 9-2350-222-20-1-5
SMOKE GENERATOR ENGINE WIRING HARNESS REPLACEMENT (Sheet 6 of 7)
6.
Install three clamps (J) on wiring harness (F).
7.
Using 7/16 inch wrench, install three screws (K) to secure three clamps (J) to engine.
8.
Temporarily place shell (L) in position in bracket (M).
9.
Measure length of wiring harness (F) to shell (L). Allow 1/2 inch for stripping and mark wiring
harness (F).
10. Using diagonal cutting pliers, cut wiring harness at mark.
11. Using wire strippers, strip 1/2 inch of insulation from end of harness (F).
Go on to Sheet 7
TA140902
23-50