TM 9-2350-222-20-1-5
GAS PARTICULATE HEATER REPLACEMENT (Sheet 3 of 5)
Using 9/16 inch socket, remove three screws and lockwashers (M) holding cover (N) to hull.
9.
Throw lockwashers away.
NOTE
You may need a pry bar to move hydraulic lines (C) away
from cover (N) for access to one of the three screws.
Remove cover (N) and heater (P) from
position in hull.
Using 1/2 inch wrench to hold four nuts, use
another 1/2 inch wrench to remove four
screws, lockwashers, and nuts (Q) holding
heater (P) to cover (N). Throw lockwashers
Remove heater (P) from cover (N).
Using 1-13/16 inch wrench to hold heater (P), use 1-1/2 inch wrench to remove adapters (F) and (J)
INSTALLATION:
1.
Using 1-13/16 inch wrench to hold heater (A),
use 1-1/2 inch wrench to install adapters (B)
and (C).
2.
Position cover (D) to heater (A).
Go on to Sheet 4
