TM 9-2350-222-20-1-5
INTERIOR RELEASE MECHANISM REPAIR (Sheet 5 of 11)
14. Using 3/32 inch punch and hammer, drive
spring pin (AH) out of shaft (AJ). Throw spring
pin away.
15. Pull handle (AK) off shaft (AH).
Using dry cleaning solvent (Item 54, Appendix
2.
Using cleaning fluid (Rem 35, Appendix D),
clean switch assembly and switch connectors.
3.
Check metal parts for cracks.
4.
Check levers, pins, pawl, and handle shaft for
bends or breaks.
5.
Check brackets for bends, elongated holes, or
damaged points.
6.
Check spring wire for nicks and grooves at
contact points.
7.
Replace all defective parts.
1.
Push handle (A) onto shaft (B). Aline spring
pin hole of handle (A) with holes of shaft (B).
2.
Using hammer, install new spring pin (C) into
handle (A) and shaft (B).
TA140930
