TM 9-2350-222-20-1-5
INTERIOR RELEASE MECHANISM CONTROL ASSEMBLY REPLACEMENT (Sheet 5 of 5)
8.
Install nut (H) onto control housing (A).
9.
Using 9/16 inch wrench, tighten nuts (F)
and (H) to secure control housing to brac-
ket (G).
10.
Pull cables (C) toward fire extinguisher
bottles until tight.
NOTE
On early model perform steps
11, 12, 13, and 14. On late
model perform steps 13.1,
13.2, and 14.
11. Install clamps (J) approximately 2 inches
from end of shorter cable.
12. Install two screws (K) into clamps (J).
13. Using screwdriver, tighten screws (K) to
secure clamps (J) on cables.
13.1. Install cables through clamps (J).
13.2. Using 7/64 inch allen wrench, tighten
screws (K) to secure clamps (J) on cables.
14. Install control valve assemblies (page 21-41).
21-22
