TM 9-2350-222-20-1-5
PERSONNEL HEATER MOUNTING CLAMP(S) REPLACEMENT (Sheet 1 of 1)
TOOLS: Flat-tip screwdriver
Metal cutting shears
PRELIMINARY PROCEDURE:
Set MASTER BATTERY switch to OFF (TM 9-2350-222-10).
REMOVAL:
1.
Using screwdriver, remove either one or all three clamps (A), as necessary.
If clamps are too rusted or old to remove, use screwdriver and pry clamp away from mounting
2.
bracket(s) (B) or heater (C). Then, using shears, cut clamp(s) free.
1.
Install new clamp(s) (A) around mounting brackets (B) or heater (C), as necessary.
Using screwdriver, tighten clamp(s) (A).
2.
TA141240
