TM 9-2350-222-20-1-5
DRIVER'S SEAT ADJUSTING ASSEMBLY REPAIR (Sheet 10 of 10)
36. Using 1/2 inch wrench on nut (AM) and 9/16
inch wrench on nut (AP), tighten both nuts.
37. Position straight pin (AS) to bellcrank (AJ) with
holes alined.
38. Using hammer and punch, install headed pin
(AT) through bellcrank (AJ) and straight pin
(AS).
39. Using pliers, install new cotter pin (AU) in
headed pin (AT).
Position lever (AV) to straight pin (AS) with
40.
holes alined.
Using hammer, install headed pin (AW) through lever (AV) and straight pin (AS).
41.
Using pliers, install new cotter pin (AX) in headed pin (AW).
42.
43.
Check all handles and levers for free movement.
Install adjusting assembly in vehicle (page 17-22).
44.
End of Task
17-32
