TM 9-2350-222-20-1-5
DRIVER'S SEAT ADJUSTING ASSEMBLY REPAIR (Sheet 7 of 10)
Assemble sleeve (R), spring (S), and washer (T)
15.
on bracket (B).
Push adjusting pin (U) through bracket (B),
16.
sleeve (R), spring (S), and washer (T).
17.
Using screwdriver, pry washer (T) away from
bracket (B) far enough to install pin (V) in
adjusting pin (U) behind washer (T).
Repeat steps 18 and 19 for four
housing assemblies (W).
18.
Position housing assemblies (W) bracket (B)
with holes and shims (X) alined.
19. Install screws (Y) thru new lockwashers (Z),
housing assemblies (W), and shims (X) into
bracket (B) and tighten with screwdriver.
20.
Position handle (AA) on bracket (B) with
upper hole in handle (AA) alined with hole in
bracket (B).
21.
Using hammer, install pin (AB) through
bracket (B) and handle (AA).
TA139230
17-29
