TM 9-2350-222-20-1-5
TOOLS: Ratchet with 1/2 in. drive (2 required)
3/4 in. socket with 1/2 in. drive (2 required)
5 in. extension with 1/2 in. drive
10 in. extension with 1/2 in. drive
3/4 in. combination box and open end wrench
Pinch bar
1/2 in. socket head screw key
REFERENCES:
TM 9-2350-222-10
TM 9-2350-222-20-2
PERSONNEL: Two
PRELIMINARY PROCEDURES: Remove plate and tray platform (page 17-13)
Traverse main gun over rear of vehicle (TM 9-2350-222-10)
Remove portable fire extinguisher mounting bracket
(TM 9-2350-222-20-2)
Remove turret traverse lock (TM 9-2350-222-20-2)
Remove master control panel mounting plate (page 10-153)
Some ammunition racks may have
socket head screws instead of 3/4
inch screws. If your ammunition
rack does have socket head
screws, use socket head screw
key to remove and install screws.
1. Using socket and 3/4 inch wrench, remove nut
and washer (A).
2. Remove screw (B).
3. Using socket with 5 inch extension and 3/4 inch wrench, remove two nuts and two washers (C).
4. Remove two screws (D) and clamp (E).
TA139208
Go on to Sheet 2