TM 9-2350-222-20-1-5
REAR DRAIN VALVE CONTROL LEVER ASSEMBLY REPLACEMENT (Sheet 2 of 4)
1.
Using pliers, remove cotter
pin (A) from clevis pin (B).
Throw cotter pin away.
2.
Using phem, remove pin (B) from clevis (C).
3.
Using hammer and 1/8 inch punch, drive pin
(D) out of lever (E).
4.
Using 7/16 inch wrench, remove two screws (F), lockwashers (G), and flat washers (H). Throw
lockwashers away.
NOTE
It may be necessary to tap lever (E) with hammer for removal.
5.
Remove lever (E) and washer (J) from shaft (K).
6.
Remove bracket (L) from vehicle.
7.
Secure bracket (L) in vise.
Using hammer and 1/8 inch punch, drive pin (M) out of control lever (N).
Go on to Sheet 3
TA140759
