TM 9-2350-222-20-1-5
DRIVER'S HATCH MOUNT LID ASSEMBLY REPgAIR (M24 IR PERISCOPE) (Sheet 2 of 3)
CLEANING AND INSPECTION:
1.
Clean all parts using dry cleaning solvent (Item 54, Appendix D) and steel wool (Item 55,
Inspect all parts for damage or wear. Replace all unserviceable parts.
2.
1.
Using vise, squeeze two bearings (A) into
lid (B).
2.
Position bumper (C) on lid (B) and cover
rubber portion with wet asbestos (Item 9,
3.
Using welding equipment, weld metal
tongs of bumper (C) to lid (B).
4.
Remove asbestos from bumper (C).
5.
Position tab of spring (D) in slot of
retainer of lid (B).
6.
Insert end of handle (E) through center of
spring (D) into hole in retainer on lid (B).
7.
Pull loop end of spring (D) beyond handle
(E) and release spring over handle to allow
spring to hold handle against lid (B).
Go on to Sheet 3
TA253600
