TM 9-2350-222-20-1-5
FENDER AND SHIELD (REAR) REPLACEMENT (Sheet 2 of 7)
2. Using 9/16 inch socket, remove three nuts (G) and flat washers (H) holding fender (E) to outrigger
No. 5 (J).
2.1 If right rear fender is being removed, use 9/16 inch socket and 9/16 inch wrench.
Remove self locking nut (J.1) washer (J.2) and screw (J.3). Throw self locking nut away.
NOTE
Plates may exist between stowage box base plate and out-
rigger to shim possible gaps. Remove and retain plates to shim
gaps during later installation.
3.
Using 9/16 inch socket, remove remaining
three nuts (K) and flat washers (L) holding
outrigger No. 5 (J) to stowage box base
plate (M).
4.
Using 9/16 inch socket on screws (N) and
9/16 inch wrench on nuts (P), remove two
screws (N), four flat washers (Q), and two
nuts (P). Remove shield (S) from taillight
bracket (T).
5.
Remove fender (E) and shield (S) from
vehicle.
Go on to Sheet 3
TA253584
16-77
