TM 9-2350-222-20-1-4
STEERING CONTROL LINK TO BULKHEAD SHAFT ROD Replacement (Sheet 2 of 2)
NOTE
If rod (D) or rod end bearing (C) must be
replaced, perform steps 5 thru 7.
Using one wrench on nut (E) and one wrench on rod end (C), remove rod end (C).
5.
Replace rod (D) or rod end (C)as required.
6.
Using one wrench on nut (E) and one wrench on rod end (C), install rod end.
7.
INSTALLATION:
1. Install rod assernbly (B) to link (F) and rod (G) as shown.
2 . Using wrench, install two bolts (A).
3. Using socket and torque wrenches, tighten bolts (A) to 15-20 lb-ft (20-27 N.m).
End of Task
TA253526
15-26 Change 1