TM 9-2350-222-20-1-4
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 12 of 13)
78.
Using 3/4 inch wrench, install nut (AJ).
79.
Using pliers, install new cotter pin (AH).
8 0 . Install 2A powerplant (page 5-14) or 2D
powerplant (page 5-37).
81.
Insert locating pin (V).
LEFT SIDE OF HULL
(TO REAR OF FUEL TANK)
LEFT SIDE OF VEHICLE
DRIVER'S STATION - LEFT REAR
82.
Attempt to insert locating pin (B).
83.
If locating pin (B) can be inserted, remove locating pins (B) and (V) and go to step 93.
1
84.
If locating pin (B) cannot be inserted, remove locating pin (B) and use 9/16 inch wrench to remove
screw (AY).
85.
Remove steering rod end and bearing (AZ) from clevis (BA).
86.
Using 9/16 inch wrench, loosen jamnut (BB).
87.
Insert locating pins (B) and (V).
Go on to Sheet 13
TA253514
Change 1 15-13
