TM 9-2350-222-20-1-4
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 9 of 13)
47. Insert locating pin (V).
48. Attempt to insert locating pin (AF).
49. If locating pin (AF) can be inserted, go to
step 69.
50. If locating pin (AF) cannot be inserted, use
7/16 inch wrench and remove screw (AG).
51. Using pliers, remove cotter pin (AH). Throw
cotter pin away.
LEFT SIDE OF HULL (TO REAR OF FUEL TANK)
52. Using 3/4 inch wrench, remove nut (AJ).
53. Pull plate (AK) out and away from linkage
assembly.
54. Install nut (AJ) finger tight.
55. Remove locating pin (V).
NOTE
If required, pull rod toward rear of
vehicle while performing step 56.
DRIVER'S STATION - LEFT REAR
56. Using 9/16 inch wrench, remove screw (AL).
Go on to Sheet 10
15-10