TM 9-2350-222-20-1-4
SHOCK ABSORBER MOUNTING YOKE BUSHING REPLACEMENT (Sheet 1 of 4)
PROCEDURE INDEX
PROCEDURE
PAGE
Front and Middle Mounting Yoke Bushings Replacement
Rear Mounting Yoke Bushings Replacement
TOOLS: Hammer
SPECIAL TOOLS: Remover and replacer (Item 9, Chapter 3, Section I)
Handle (Rem 12, Chapter 3, Section I)
TM 9-2350-222-10
REFERENCE:
PRELIMINARY PROCEDURE: Remove shock absorber (page 14-95)
Front and Middle Mounting Yoke Bushings Replacement
REMOVAL:
NOTE
Replacement procedures are the same for the front and
middle mounting yoke bushings except where noted.
1.
For ease of removal of middle mounting
yoke bushings, remove two track center
guides at position (A) (to rear of middle
mounting yoke (B) (TM 9-2350-222-10).
Position remover and replacer (C) on rear
2.
bushing (D) of mounting yoke (B).
3.
Position handle (E) on remover and
replacer (C) and, using hammer, drive rear
bushing (D) out of mounting yoke (B).
4.
Remove handle (E) and remover and
replacer (C).
Go on to Sheet 2
14-98.1
Change 5
