TM 9-2350-222-20-1-4
SHOCK ABSORBER MOUNTING YOKE BUSHING REPLACEMENT (Sheet 4 of 4)
Rear Mounting Yoke Bushing Replacement
INSTALLATION:
1. Position rear bushing (A) on remover and
replacer (B) and aline bushing (A) in
mounting yoke (C).
2 . Position handle (D) through mounting yoke
(C) or remover and replacer (B) and, using
hammer, drive bushing (A) into mounting
yoke (C) until flush with surface.
3. Remove handle (D) and remover and
replacer (B).
4 . Position forward bushing (E) on remover and
replacer (B) and aline bushing (E) with
mounting yoke (C).
5. Position handle (D) on remover and replacer
(B) and, using hammer, drive bushing (E)
into mounting yoke (C) until flush with
surface.
6. Install shock absorber (page 14-96).
End of Task
14-98.4
Change 6
