TM 9-2350-222-20-1-4
SHOCK ABSORBER BEARING REPAIR (Sheet 2 of 2)
Position remover (E) onto longer threaded
5.
end of screw. Remover (E) should mate to
surface of bearing (D) at other side.
6.
Screw nut (F) onto longer end until it mates
with remover.
7.
Put shock absorber in vise.
8.
(F) of special tool to force bearing (D) out of
shock absorber.
9.
Throw bearing away.
ASSEMBLY:
1.
Using special tool (Item 26, Chapter 3, Section
I) as shown, install new bearing (A) in shock
absorber.
2.
Using hammer and center punch, stake
bearing (B) (three places, each side) to hold
bearing in place.
3.
Install shock absorber (page 14-96).
End of Task
TA253506
14-98 Change 1
