TM 9-2350-222-20-I-4
T142 TRACK LINK REPLACEMENT (Sheet 2 of 3)
NOTE
Position link to be replaced between
compensating idler wheel and road-
wheel No. 1. Disconnect track at
link to be replaced. It will be
necessary to remove end connectors
and centerguyide on both sides of
link.
REMOVAL :
1.
Using 15/1 6 inch socket with ratchet,
loosen bolt (A) securing wedge (B) to end
connector (C).
2.
Using hammer, tap wedge (B) to loosen
it.
3.
Remove bolt and wedge. Throw both
Parts away.
4.
Repeat steps 1 thru 3 to remove bolt and
wedge at opposite side of track.
5.
Put hook (D) of puller and pump behind
end connector (C).
6.
Aline studs (E) of puller with shoe pins
(F).
7.
Pump handle (G) until end connector (C)
comes off.
8.
Repeat steps 5, 6, and 7 to remove
opposite end connector.
G O on to Sheet 3
Change 5 14-93
