TRACK ASSEMBLY REPLACEMENT (Sheet 8 of 10)
27. Speed engine just enough so person pulling on rope can steer track up over all support rollers and
compensating idler wheel.
When track is over compensating idler wheel, is tight around sprocket, and is ready to be connected,
shut down engine. Apply parking brake (TM 9-2350-222-10).
Shorten track adjusting link as much as possible (TM 9-2350-222-10).
Using crowbar lift lower end of track up.
31. Connect track connecting fixtures (F) to sides of
track. Make sure fixtures are around end pins
(H) and remove rope (D).
3 2 . Using tool handle, tighten up both fixtures (F)
until end connector (G) can be started over
track end pins (H).
Go on to Sheet 9
14-88 Change 1