TM 9-2350-222-20-1-4
TRACK ASSEMBLY REPLACEMENT (Sheet 4 of 10)
Using 1-5/16 inch socket with hinge handle and
13.
extension, loosen nut (G) securing centerguide
bolt (H).
Using sledge hammer, strike centerguide (J) to
14.
loosen it.
Remove nut (G), centerguide (J), cap (K) and
15.
bolt (H).
Using tool handle, loosen both track fixtures
16.
(D).
Using crowbar to support track, remove fixtures
17.
(D). Let track fall free to separate.
Start engine and put transmission in R
18.
(reverse) (TM 9-2350-222-10).
Move steering control handle away from track
19.
being removed. Use brake to control slow speed
until track is off sprocket (L).
INSTALLATION:
If track is to be replaced and roadwheels are
1.
still on track, position new track (A) to mate
with old track (B) as shown.
If roadwheels are on ground (old track (B)
2.
removed), use plank (C) as shown.
NOTE
If plank (C) or similar object is not
available, dig a hole under first
few links of new track.
Make sure new track (A) is in line with
3.
roadwheels (B).
Start engine (TM 9-2350-222-10).
4<
TA253493
Go on to Sheet 5
14-84 Change 1
