TM 9-2350-222-20-1-4
SUSPENSION TORSION BAR REPLACEMENT (Sheet 3 of 7)
8.
Using crowbar (or pinch bar), apply upward
force to bottom of roadwheel arm (F).
Have second person position blocks under arm
9.
(F) while force is being applied.
..
10. Remove crowbar.
11. Using automotive wrench, screw adapter
into threaded hole of torsion bar (E).
NOTE
Adapter must be tightened after
each striking movement.
12. Using slide hammer puller with adapter,
strike torsion bar (E) with slide hammer by
sliding slide hammer puller along slide
hammer rod.
13. Keep on striking torsion bar (E) with slide
hammer. Hammer with some force until
torsion bar (E) spline is free from side of hull.
Pull bar (E) out of support arm (F).
14
Go on to Sheet 4
Change 5
14-26
