TM 9-2350-222-20-1-4
BRAKE RIGHT HAND SLAVE CYLINDER AND TUBE ASSEMBLY REPLACEMENT
(Sheet 2 of 6)
1.
Position container under tube (A) and tee
(B) to catch brake fluid.
2.
Using 11/16 inch wrench, disconnect tube
assembly (A) from tee (B).
NOTE
Allow brake fluid to drain,
then throw fluid away.
3.
Using 7/16 inch socket, remove screw (C),
lockwasher (D), and clamp (E). Throw
lockwasher away.
4.
Using 13/16 inch wrench, loosen bolt (F)
from slave cylinder.
5.
Remove bolt (F), tube assembly (A), and
two gaskets (G) as an assembly from slave
cylinder (H). Throw gaskets (G) away.
6.
Install plastic cap on tee (B).
7.
Using 11/16 inch wrench, remove cap (J).
7.1
Using adjustable wrench to hold tee (K),
use 11/16 inch wrench and remove tube
assembly (L) and (M) from tee (K).
8.
Using 9/16 inch socket, remove screw (N),
lockwasher (P), and bracket (Q). Throw
lockwasher away.
NOTE
Replace screw (N) and new lockwasher (P) to hold adjusting
screw lock plate in place until installation of bracket (Q).
Go on to Sheet 3
TA253434
Change 1 13-65
