TM 9-2350-222-20-1-4
BRAKE LEFT HAND SLAVE CYLINDER AND TUBE ASSEMBLY REPLACEMENT
(Sheet 2 of 4)
1.
Position container under slave cylinder (A) to
catch brake fluid.
2.
Using 13/16 inch wrench, remove bolt (B) and
two gaskets (C). Throw gaskets away.
NOTE
Allow brake fluid to drain, then
throw fluid away. Check bolt (B)
to make sure internal passages are
open and clean.
3.
Using 11/16 inch wrench, disconnect nut on
tube assembly (D) from tee (E) and install
Plastic cap on tee.
4.
Install plastic plug in nut of tube assembly (D)
and masking tape (Item 57, Appendix D) over
Parts in other end.
5.
Using socket, disconnect mounting nut (F) from
stud (G).
6.
Move slave cylinder (A) forward and wiggle it
side to side while pulling up until catch (H)
clears housing assembly. Continue this
procedure until it comes loose from housing
assembly (J).
7. Using putty knife, remove packing (K) from
groove of slave cylinder (A) and throw away.
GO on to Sheet 3
TA140368
13-61
