TM 9-2350-222-20-1-4
PARKING BRAKE CABLE ADJUSTMENT (Sheet 3 of 4)
7.
Using ruler, measure distance between nut
(J) and clevis (K) after brake cable (E) is
pushed inward as far as possible. Record
reading.
8.
Pull brake cable (E) outward 3/4 inch
farther than reading taken in step 7.
NOTE
Do not change 3/4 inch posi-
tion when performing steps 9
and 10.
9.
Position clevis (K) in bellcrank (F). Insert
pin, washer, and new cotter pin (D). Do
not allow cable (E) to turn, or damage will
result. Nuts and clevis must thread freely
on cable (see step 10).
If pin cannot be freely inserted in clevis
10.
(K), using 15/16 inch wrench, loosen two
nuts (L) and adjust cable travel maintain-
ing distance in step 8 until clevis (K) and
bellcrank (F) will aline. Tighten two nuts
(L) after inserting pin, washer, and new
cotter pin.
NOTE
between clevis and locating
pin during this adjustment
procedure. It may be neces-
sary to grind clevis as shown
Go on to Sheet 4
TA253427
13-22 Change 1