TM 9-2350-222-20-1-4
ENGINE WIRING HARNESS REPLACEMENT (2.D ENGINE) (Sheet 6 of 12)
Using slip joint pliers, remove electrical
connector (AZ) from ignition unit (BA).
Using 7/16 inch socket, remove two screws
and lockwashers (BB) securing clamp (BC).
Throw lockwashers away.
Remove clamp.
Using 1/2 inch socket, remove nut (BD)
43.
securing clamp (hidden).
Remove clamp.
44.
Using 1/2 inch socket with extension, remove
45.
screw and lockwasher (BE) securing clamp (BF).
Throw lockwasher away.
Remove clamp (BF).
46.
Using spanner wrench, disconnect electrical
47.
connector (BG) from low voltage protection
relay (BH).
Using cutting pliers, cut and remove two plastic
48.
straps (BJ) from cables (BK).
Using 3/4 inch wrench, remove nut and
lockwasher (BL). Throw lockwasher away.
Remove three cables (BK).
Using flat-tip screwdriver, remove screw
(BM).
Remove electrical cable (BN).
53. Remove engine wiring harnessfrom engine.
Go on to Sheet 7
TA139895
10-344
