TM 9-2350-222-20-1-3
ENGINE COOLING FAN SHROUD REPLACEMENT (Sheet 3 of 8)
Using pliers, remove cotter pin (J) from nut (K).
Throw cotter pin away.
Using 1-1/4 inch socket, remove nut and
washer (K) securing rear fan (L) to engine,
10.
Lift fan (L) from engine.
NOTE
Four nuts (N) are located under
fan shroud and hold fuel line
clamps.
When nut (N) and
screws (P) are removed. clamps
will remain on fuel line.
11.
Using 1/2 inch socket, remove three screws (M).
12.
Using 1/2 inch wrench to hold nuts (N), use 1/2
inch socket and remove four screws (P) and
nuts (N).
13.
Using 1/2 inch socket, remove five screws (Q)
securing shroud (D) to engine.
FRONT OF ENGINE
TA140287
Go on to Sheet 4
9-53
